Vapor linker exchange of partially amorphous metal–organic framework membranes for ultra-selective gas separation

Metal–organic framework (MOF) membranes are promising for efficient separation applications. However, the uncontrollable pathways at atomic level impede the further development of these membranes for molecular separation. Herein we show that vapor linker exchange can induce partial amorphization of MOF membranes and then reduce their transport pathways for precisely molecular sieving. Through exchanging MOF linkers by incoming ones with similar topology but higher acidity, the resulted metal-linker bonds with lower strength cause the transformation of MOF membranes from order to disorder/amorphous. The linker exchange and partial amorphization can narrow intrinsic apertures and conglutinate grain boundary/crack defects of membranes. Because of the formation of ultra-microporous amorphous phase, the MOF composite membrane shows competitive H₂/CO₂ selectivity up to 2400, which is about two orders of magnitude higher than that of conventional MOF membranes, accompanied by high H₂ permeance of 13.4 × 10⁻⁸ mol m⁻² s⁻¹ Pa⁻¹ and good reproducibility and stability.     

内含实体对H型垂直轴风力机气动性能的影响

以H型垂直轴风力机及其内含圆柱形实体为研究对象,对NACA0018翼型的五叶片H型垂直轴风力机的气动性能进行数值模拟和实验验证。分析8种不同直径的内含圆柱体,在内含实体截面积占风轮迎风面积之比分别为21.2%、50.0%和76.9%时,风力机风能利用率的峰值分别下降8.04%、20.7%及74.3%。结果表明：随着内含实体直径的增大,风能利用率的峰值逐渐减小,开始较为缓慢,达到一定值时快速下降。小直径内含实体主要影响叶片在下风区的转矩,对风能利用率的影响较小,而大直径内含实体还会影响叶片在上风区的转矩,其风能利用率迅速减小。对于内含固定直径的实体,比如在现有建筑物外侧安装风力机时,其风轮半径的选择需综合考虑风能利用率和风力机的建造成本两方面的因素。研究结果可为建筑物与垂直轴风力机进行有效结合以提高风能的利用提供参考。     

Stabilization for Schrödinger Equation with Internal Damping and Boundary Disturbance

In this paper, the stabilization for Schrödinger equation subject to internal damping and boundary disturbance at the control end is investigated. Due to its immeasurability, the nonlinear observer system is designed to obtain the state information, and the existence of weak solution and its convergence for the nonlinear observer system are proved. The feedback control is realized by the backstepping transformation. In addition, the adaptive disturbance rejection control is applied to estimate the disturbance. According to the observer and disturbance estimation, the feedback control is finally designed to stabilize the system asymptotically.

     

Performance of a Degassing Cyclone with Main and Subsidiary Chambers

Based on the premise that large bubbles are removed in larger cyclones and small bubbles in smaller cyclones, a combined degassing cyclone with main and subsidiary chambers was designed to enhance liquid degassing. The pressure loss, liquid flow rate at the gas outlet, split ratio, gas flow rate at the liquid outlet, and degassing efficiency of the degassing cyclone were measured and calculated. Pressure loss correlations were established which relates the Euler number to the gas and liquid Reynolds numbers in the main chamber. Most cases exhibit a degassing efficiency greater than 0.998 when the liquid flow rate is more than 0.7 m³h^?1. The contours of pressure loss, split ratio, and degassing efficiency provide an effective guidance for designing a degassing cyclone.     

特低渗砂岩油藏CO2-低界面张力黏弹流体协同驱油机理研究

目的特低渗油藏储层物性差、层间非均质性强,造成CO₂驱易发生气窜,提高采收率效果欠佳,其中,CO₂水气交替驱作为结合CO₂驱和水驱优势的方法,具有较高的适用性。为进一步改善CO₂-水交替驱的开发效果,开展了CO₂-低界面张力黏弹流体协同驱油研究。 方法通过界面张力和润湿性能测试评价低界面张力黏弹流体基本性能,并利用微观可视化驱油实验及岩心驱油实验等,探究了不同驱替方式的驱油效果和CO₂-低界面张力黏弹流体协同驱油过程中二者之间的“协同作用”机理。 结果低界面张力黏弹流体具备良好的界面活性和改变岩石表面润湿性能力,水驱后开展CO₂驱、低界面张力黏弹流体驱、CO₂-低界面张力黏弹流体交替协同驱,采收率可在水驱基础上分别提高0.91%、10.66%、16.25%,其提高采收率机理包括降低界面张力、改善流度比、改变岩石表面润湿性及乳化作用的协同效应等。 结论CO₂-低界面张力黏弹流体协同驱既可有效增强非均质特低渗砂岩油藏注CO₂过程中气体流动性控制,又能够降低CO₂萃取轻烃导致重质组分沉积的影响,具有协同增效作用。      

Effect of microwave heating time on the gel properties of chicken myofibrillar proteins and their formation mechanism

The present work was conducted to illustrate the mechanism of gel formation of myofibrillar proteins (MPs) under different microwave heating times. The results showed that the denaturation enthalpy (ΔH) of the MPs significantly decreased when the heating time increased from 3 to 9 s and then completely disappeared as the heating time progressed, indicating that the MPs gradually denatured and subsequently aggregated with increasing heating time, which was further verified by the changes in the secondary structure, electrophoretic bands, and gel properties (e.g., water holding capacity and textural profiles) of the MPs. Microstructural images indicated that the MP gel formed under 12 s had the most compact network, indicating that extended microwave heating time could induce quality deterioration of MP gels. Moreover, the hydrophobic forces, electrostatic forces, and disulphide bonds of the MPs gradually intensified with increasing microwave heating time, suggesting that both non-covalent and covalent bonds could promote molecular denaturation and subsequent aggregation of MPs. In addition, correlation analysis revealed that the changes in the molecular conformation of MPs induced by different microwave heating times could effectively regulate the formation of MP gels and their related properties.     

Protein from Hylocereus polyrhizus protects MRC-5 cells against hydrogen peroxide (H2O2)-induced damage

Food Science and Biotechnology - The cytoprotective and potential molecular mechanisms of Hylocereus polyrhizus protein (RFPP) were investigated on the hydrogen peroxide (H2O2)-triggered damage in...     

ZnO·2.7Al2O3 nanocomposite with high optical transparency

Here we report a transparent dual-phase ZnO·2.7Al₂O₃ ceramic. The composite is pore-free and consists of thin nanosheets with a spinel phase and a hexagonal phase, while the two phases match closely in both lattice and refractive index. Such features result in excellent optical transmittance (maximum value >80% in the visible spectrum) at comparable phase volume. This work may provide a new thought for the rational structural design of optical nanocomposites.